Warthunder 3.0 Feedback

[BlackSword]

Works well in Range Combat but Closecombat in tanks it aims to low, and wen i audujust it aims range to high.
in tanks that are not moving it dont aim the middle it aimsa bit in the moving direction.
ST.Emil

that in my Tiger 2 Sla 1.6
same Problem, enemy @ 700m hits nice under and above it fails totaly, and if i adujust with up and down, it aims well @ 1km but canot aim anything in ranges under that fails totaly, same wen i change it to 200m 300m is failing.
im using the advanced setting, wo the bot chose auto the bullet speed and mass.
https://picload.org/image/roggilli/shot2017.01.0911.14.04.jpg

[Man-of-Albion]

BlackSword
Thanks :)

[BlackSword]

i think there is an problem with the bullet mass, if i play around with that its bether but the same problems still there

edit// difrent mution used, dont work. it works only in an range like 500m then u need to audujust. for the new range manualy. i play RB mostly and its not helpfull.

[peacealex29]

Same problem. Prediction to distant targets can be set manually but then not enough prediction for the close targets - shot are flying too low. At any tank values taken from wiki.warthunder do not give any results - shot do not hit the target at any distance.

[KamisExperiment]

Thank you for the feedback.

[optickfiber]

I can confirm this, the values are not working.

[MULISHA]

I will forward this to the coder
thank guys

[MoNk3ey]

Well,

can you tell me which tank exactly you guys reffer to and what values you exactly are setting in the advanced tab.

Thanks,
MoNk3ey

[caspercasper]

Im using Pz III. M and I can't get this cheat working at all, only esp works fine

[alexma01]

I tested on the Type61, and did set the values to the correct ones, but the aim would be too high. (Uses HEATFS)